Micro-Swiss CM2™ Düse RepRap 1,75 mm, 0,4 mm

Bewertet mit 5 von 5 Sternen.

Druckt einwandfrei, Support sehr gut

Druckt, wie sie soll. Zuerst habe ich sie, wie meine anderen Düsen, mit einer Messingbürste gereinigt. Dann kam mir in den Sinn, dass ich damit vielleicht die Nanobeschichtung abkratzen könnte. Eine Anfrage per E-Mail dazu wurde am nächsten Tag wie folgt beantwortet:
"
Thank you for reaching out. The best way to clean the nozzle is to preheat it to the printing temperature of the filament you were using, then wipe away the softened residue with a paper towel folded over a few times. That said, the WS2 coating is a very thin surface treatment and will gradually wear over time even with normal use. If you have charred plastic buildup on the nozzle tip that doesnt come off using a paper towel, it's generally better to remove it using a brass brush, rather than to leave it there just to preserve the remaining coating. In our printer farm, we use both methods depending on the situation. Using a brass brush occasionally to remove stubborn residue has not caused any noticeable degradation in nozzle performance, so brushing the nozzle 2 or 3 times should not have ruined your nozzle.
"